Sky TV in Valencia. UK TV in Valencia. Satellite TV News and Information
Xativa and Ontinyent Tourist Information
All content used on this site are protected by copyright and should not be used without expressed permission. (C)2003 - 2012 J Worby
Costa Blanca Free Adverts and Business Directory
Sky TV in Valencia. UK TV in Valencia. Satellite TV News and Information
Xativa and Ontinyent Tourist Information
All content used on this site are protected by copyright and should not be used without expressed permission. (C)2003 - 2012 J Worby
Costa Blanca Free Adverts and Business Directory
Forced Software Download for Sky Receivers
Sky Digiboxes normally update their software automatically overnight, but occasionally you may need to do a Forced Software Download. This may be required if your digibox has not been used for a while, and it has missed an update, or if the software gets scrambled for any reason.
The manual forced software update should not really be needed. In most cases the digibox will self update the software automatically, so in the first instance, just continue to use the sky box as you would normally. You will know if the software has been updated as you may find the digibox reset itself whilst you are viewing a channels.
If the process does actually need to be done, the best time of the day to do this is first thing in the morning - when signals strengths are the best, and you are able to receive the 11778 main default transponder frequency, as this is the frequency where the software updates are located.
1) Put the box into Standby mode. (red light mode)
2) Disconnect the power to the receiver
3) Locate the button on the front of the Receiver, named "Back Up". ( ON THE RECEIVER NOT ON THE REMOTE!)
4) Press and hold down the "Back Up" button.
5) WHILE HOLDING IT DOWN, reconnect the power to the receiver (do not release the back-up button yet).
6) About 20 seconds after reconnecting power, all four coloured lights will illuminate on the front of the receiver. If the TV is switched to Sky a message will also appear on screen.. "Updating System Software".
7) Only after the four lights illuminate and the message appears should you release the back-up button.
8) After about 10 minutes the receiver will return to "standby" (i.e.. red LED only).
9) Leave the receiver in standby for 1 minute as it carries out a self check.
10) Switch receiver out of standby (green LED illuminates).
11) The receiver will take a few minutes "Searching For Listings".
You may have to assists the receiver in booting up by using the "Changing Default Transponder" method
12) Your digibox should now be operating on the latest available version of software.
Do not unplug your Skybox from the mains supply or satellite dish during the software upgrade or permanent damage could be done and your box rendered unusable
Do not attempt a firmware upgrade if your Sky Digibox already has the latest firmware version - it will make no difference!